Module

EDUstick® extrusion drive

Swap the module, keep the room running

EDUstick® extrusion drive is the filament feeding and extrusion module of the EDUstick® system, sold as a product in its own right. It is not tied to one device: the same drive works with the EDUstick® SOLO and the EDUstick® Co-LAB, in blue and in purple, and it is exchanged on its own without replacing the device it works with.

Check the price in the shop
EDUstick extrusion drive in purple
EDUstick 3D pen with drive unit in blue
2 Colourways
2 Lines: SOLO and Co-LAB
1 Own product code and EAN

How it works in a workshop

A module you replace without replacing the pen

  1. Order it by number

    The drive carries its own product code and EAN, so a specific unit is ordered the same way as any other product.

  2. Pair it with a pen

    The same drive works with SOLO and Co-LAB, in both colourways. A blue drive works with a purple pen and the other way round.

  3. Keep one in reserve

    When a unit goes out of circulation, the workstation carries on with the spare. The lesson does not stop.

EDUstick 3D pen with its drive unit attached, in blue
Keeping the pen and the drive separate is the foundation of the whole range.

A product, not a spare part

The drive carries its own product code and its own EAN. It is ordered and replaced on its own.

One drive, every EDUstick® pen

The same unit works with the EDUstick® SOLO and the EDUstick® Co-LAB, in blue and in purple.

Exchange the drive, keep the pen

When a drive is worn, the drive is what changes. The pen stays in the room.

A spare keeps a lesson running

One drive in reserve and the group carries on when a single unit goes out of circulation.

Standalone productInterchangeableWorks with SOLOWorks with Co-LABTwo colourwaysDesigned in Europe

Why it exists

A drive you can buy on its own

An EDUstick® set is two separate, interchangeable products: the device and the extrusion drive. Each of them is available on its own, and this page is the drive.

That is how the range is built. The working module has its own identity, its own product code and its own EAN, so it can be exchanged, doubled or kept in reserve without touching the rest of the equipment.

What it is

The module that feeds the filament

  • A standalone module. The drive feeds and extrudes the filament. It is ordered and replaced as its own product.
  • Shared across the range. The same drive works with the EDUstick® SOLO and the EDUstick® Co-LAB, in both colourways. A blue drive works with a purple pen and the other way round.
  • Exchanged, not replaced whole. When a drive is worn or damaged, the drive is what changes. The device stays where it is.
  • A spare for the room. One drive kept in reserve means a lesson carries on when a single unit goes out of circulation.
  • The architectural foundation. Keeping the device and the drive separate is how we design the whole EDUstick® range. The family grows on this shared component, and every new device uses the module already sitting in the workshop.

Specification

Compatibility
EDUstick® SOLO and EDUstick® Co-LAB
Colourways
Blue, Purple
Product code (blue)
EDU005001(BL) · EAN 5908455420105
Product code (purple)
EDU005002(PO) · EAN 5908455420112

Warranty and full technical data: product page in the shop.

One drive. Every EDUstick® pen it works with.

Compatibility, what ships and delivery: product page in the shop.

Check the price in the shop
Write to us